Designed to keep your AirPods charged and at the ready. Use it as a headphone stand or add a lightning cable (link below) to add charging capability.
Fits AirPods Max (lightning cable version).
Note: This design will only fit the lightning cable linked below. It will not fit other lightning charging cables.
Print Recommendations: Print Material: PLA Infill Percent: 15% Perimeters: 2 Layer Height: .2 (the tolerances on this design are very precise and all other layer heights will not work if you are adding the lightning cable for charging capability) Supports: NONE Print Orientation: Place the holder on the build plate standing upright essentially in the orientation in which it will be used.
Additional Parts Required: • Braided lightning cable - (Lightning to USB-C) Amazon link: https://a.co/d/eyiupJM Note: this design is made specifically for this lightning cable. Other cables will not fit. • Double Sided Tape - Amazon Link to 3M .4 inch double sided tape https://a.co/d/3n44GFr (This adhesive twists off easily and doesn't leave residue.)
Assembly:
- Press the lightning cable into the charging stand. This is a tight fit by design so you will need the handle of a tool or another hard flat object to push the connector into the stand.
- Pull the lightning cable cord taught and push it into the groove on the base of the stand.
- Place a small square of double sided tape to each corner of the base of the headphone stand before securing it to your desk.