A fun little tin container!

I made two versions of the tin container, one with a label and the other is a plain version!

⚙️Slicer Settings

• 3 walls, 15% gyroid or 3D honeycomb infill, no supports required

• If you are finding the lid to be tight, try opening and closing it several times to loosen it up, if it's still too tight scale down 0.5% - 1%

Editing 3MF

• Please note that 3MFs will load with a custom profile that I used to print these models. Double check your settings prior to printing.

This drop contains just the tin container, for the piggies check out the piggy boops release. + + ⭐As with all of my designs, I strongly advise that the printed models are not to be handled by children under 3 without proper supervision⭐

I do not use AI in ANY part of my design process. All of my designs are human made™

📌This model is for PERSONAL USE ONLY, to sell prints of these designs you will need to SUBSCRIBE TO THE MERCHANT PLAN available on my profile page - Click here📌