Adjustable rectangle phone stand

Phone stand that uses a rectangle piece to set the angle. The three angles can be seen in the pictures.

How to print

• Print main part with large brim (e.g. 6mm), no support.
• Print the decoration strips twice and insert them.
• The picture shows you 100% size. It can hold a tablet, but at 150% or so, it's obviously more sturdy.

How to use

• Insert the rectangle in the backside of the main part to set the angle.
• Insert it from the top (see last picture) to store it, or carry it in your pocket, etc.

Origin story

When I was ready with my other adjustable phone stand there were a couple of things I wanted to improve. This design is better looking, easier to use, prints quicker and is more stable.

Potential updates

I'm thinking about adding a icon insert on the flat part, like a ★, ♥ or ♪, should I do that?