Mini drum stick

gpu support with customisable height. Works for a gpu that has a gap with 6-9cm in between the gpu and the bottom.

Gaming PC GPU support

Gpu support top.stl

This phone stand has 3 different tilt positions that lock into place. Best printed standing on its side with supports to avoid the hinge fusing to the sides (shown in photos)

Phone stand with tilt adjustment

Tic Tac Toe, but 3D.
Print the base, print 14 naughts, and print 14 crosses.

3D Tic Tac Toe

Tic Tac Toe, but 3D.
Print the base, print 14 naughts, and print 14 crosses.

Normally when storing, there would be one left over, so I like to put all the naughts in, then shove the left over cross in between over crosses (shown in photos). it shouldn't fall out.


tic tac toe base.stl

This is a phone mount that you screw onto a tripod, it uses the standard tripod thread.

It will need to be assembled. You could use glue as a permanent solution or tape is a if done.

Note: This design uses springs. you can use 
2-3 pen springs and that should work fine.

Phone mount for a tripod

tripod with parts 1 2 3.stl

Dice

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

charliemoore78

Achievements

Seedling

Debutant