Spool Mount for the Peopoly Magneto X

This is an alternate spool mount for the Peopoly Magneto X 3d printer.

I did not like the stock mount that came with the printer. I thought it was too flimsy and I had some spools fall off while printing. So, I designed this sturdy spool mount

This mount uses the existing threaded holes on the left hand side rail. I used M4x12 and M3x16 screws to attach this to the printer.

You may want to add some very light grease or dry lube to the sleeves that go over the rollers. Then attach the roller end caps with glue.