Magnetic Glock Mag Holder

Magnetic Glock Mag Holder

Rotate 180 degrees such that no support would be required on the side with the countersink holes

Estimated time: 3h 15min

Nozzle size: 0.4mm

Estimated weight: 29g

Material: PLA

Layer height: 0.28mm

Infill: 15-25%

Support: Yes (Only for largest hole)

Raft: No

Additional Material: -2 x M5 screws / two way tape -22mm (diameter) magnet

Post Printing: -Super glue the magnet in the middle hole at the base -Attach to a surface either using the screws or two way tape