oliver L

Stretchy, Slinky Pumpkin

by
Flexi-Maker
Follow
Follow
Remix Model
Flexi-Maker
Flexi-Maker
|
Image 1 of 8
Stretchy, Slinky Pumpkin 3d model
Flexi-Maker
Flexi-Maker
|
Image 1 of 8
Stretchy, Slinky Pumpkin 3d model
2D
3D
Makes
Stretchy, Slinky Pumpkin 3d model
Stretchy, Slinky Pumpkin 3d model
Stretchy, Slinky Pumpkin 3d model
Stretchy, Slinky Pumpkin 3d model
Stretchy, Slinky Pumpkin 3d model
Stretchy, Slinky Pumpkin 3d model
Stretchy, Slinky Pumpkin 3d model
Stretchy, Slinky Pumpkin 3d model

3D PRINTING SETTINGS: PLA works best. Layer height 0.2 mm 15 % filling No supports required

The slicer shows a lot of warnings, please ignore that. The program detects the distance between the individual layers. This "space" is wanted and necessary to separate the layers afterwards. It prints well even without supports.

After the pumpkin is printed, the layers are separated from each other with a knife or scalpel.

Note: The layers are best separated from each other immediately after printing, if you missed this, let it overflow with hot water.

Wenn nach dem entfernen die schichten weit auseinander sind wie auf dem zweitem und dritten Bild , drücken Sie das Modell fest zusammen und Giesen heißes Wasser über. (Achtung nicht zu heiß sonst verbrennt ihr euch die Finger) Um den Vorgang zu beschleunigen kaltes Wasser überkippen.


20 Likes95 DownloadsOctober 19, 2024



20 Likes95 DownloadsOctober 19, 2024