2D3D
Makes
Be the first to upload a Make
This model is restricted by licensing terms.
View license.
Some Creality Spider hotends are slightly taller than the standard one. This spacer combined with 2 M3x10 or 12mm screws are used to extend teh reach of the CR touch to fit these new hotends.
I suggest using ASA or similar filament, 100% infill. No support needed but a brim is helpful.
NOTE! Still in development! Changes may occur.
Categories:
1 Likes2 DownloadsSeptember 8, 2023
1 Likes2 DownloadsSeptember 8, 2023
This model is restricted by licensing terms.
View license.