Hey Guys, this is probably one of the best upgrades you can do to your S1 pro
this aligns the probe with the nozzle on stock hot ends, this is needed for couple of reasons but the most obvious is if you suspect you have a bent Y extrusion the new offset will be
x_offset: -47 y_offset: 0
Please note that some deviation is expected and you should still check that yours is zero but its my experience that even if this is off by 1 or 2 mm, it makes a big improvement over the stock position.
There are two versions, one that can take M3 insert and the other screw in directly.
Remember to set your new offset in config.
Category:
5 Likes7 DownloadsFebruary 26, 2024
5 Likes7 DownloadsFebruary 26, 2024