EngineerMeThis

Welcome to EMT, A place for practical useful models and designs that can be used around the house, workshop and office. You will not find any toys on our page.

We do have Etsy Shop for most of our items but it is not our main focus, all designs are available for outright purchase if you have commercial objectives and requests are welcome.

https://engineermethis.etsy.com

We are setting up a monthly membership and if you want to support us plus get access to the 5 files we will do per month for personal and commercial use please like, follow and stay tuned for the launch.

Select a membership plan

Commercial License Plan

$10.00

/ month

So you all have been asking, So here we are. Although I will carry on uploading models for everyone enjoyment, if you want or need to sell any of these models, this is the honest way of doing so, I will strive to upload at least 5 new models each month and paying members gets to request changes for considerations.

Immediate access. Cancel anytime.

S1 Pro Probe-offset

EngineerMeThis

Remix Model

Social

Become a member

Makes

Hey Guys, this is probably one of the best upgrades you can do to your S1 pro

this aligns the probe with the nozzle on stock hot ends, this is needed for couple of reasons but the most obvious is if you suspect you have a bent Y extrusion the new offset will be

x_offset: -47 y_offset: 0

Please note that some deviation is expected and you should still check that yours is zero but its my experience that even if this is off by 1 or 2 mm, it makes a big improvement over the stock position.

There are two versions, one that can take M3 insert and the other screw in directly.

Remember to set your new offset in config.

Category:

3d Printers

Creality

Tags:

5 Likes7 DownloadsFebruary 26, 2024