tracking pixel
Dead.Pixel

Sanding Block / Sanding Tool with Handle

by
Dead.Pixel
Follow
Follow
Remix Model
Dead.Pixel
Dead.Pixel
|
Image 1 of 4
Sanding Block / Sanding Tool with Handle 3d model
Dead.Pixel
Dead.Pixel
|
Image 1 of 4
Sanding Block / Sanding Tool with Handle 3d model
2D
3D
Makes
Sanding Block / Sanding Tool with Handle 3d model
Sanding Block / Sanding Tool with Handle 3d model
Sanding Block / Sanding Tool with Handle 3d model
Sanding Block / Sanding Tool with Handle 3d model
This model is restricted by licensing terms. 

Small simple tool to sand small parts. Dimensions: 100mm x 50mm x 40mm. The handle provides a more ergonomic grip and skewed sides allow it to reach narrow parts or sharp inner corners.

Instructions

Requires non-3D printed parts:

  • 1x M5 Screw with low profile cap (15-27mm long)
  • 1x M5 Nut

Despite it can be printed without supports I would recommend using a small support for the hole in the base part.

Print all three parts. Put M5 nut inside the printed “Nut” part. Place “Nut” inside “Handle” making sure that metal nut is on top. Put the screw through the hole at the bottom of “Base”, then through “Handle” with “Nut”. Turn the “Nut” until it will be tighten enough.


3 Likes10 DownloadsAugust 30, 2024



3 Likes10 DownloadsAugust 30, 2024
This model is restricted by licensing terms.