DaveMakesStuff

Woven Ball

by
DaveMakesStuff
Follow
Follow
Remix Model
2D
3D
Makes
Woven Ball 3d model
Woven Ball 3d model
Woven Ball - Looks good without soluble supports at 50% - 3d model
This model is restricted by licensing terms. 

This Woven Ball is impossible to print. Unless you use water soluble PVA filament for supports!

See here for video: https://youtu.be/o5lJ5TMQRpk

The top inside of the ball has overhangs that need to be supported or the print will fail. Typical supports can’t be use because the holes are too small to allow removal of supports from inside the ball. With PVA filament, you can use all the supports you need, soak the finished print in warm water, and watch the supports simply dissolve away!

This model printed with my Snapmaker J1 IDEX printer using Snapmaker PVA filament and Sunlu White PLA.


140 Likes292 DownloadsJune 30, 2023



140 Likes292 DownloadsJune 30, 2023
This model is restricted by licensing terms.