Modular Holder for Phone or Tablet Document Camera

This modular holder allows you to position your phone or tablet as a document camera.

The height is adjustable, and the device can also be rotated to face the user. All parts are symmetrical, so the base can be oriented for both right- and left-handed users. It is possible to attach multiple devices at once.

When placing your phone or table in the holder, try to position the camera as close to midline as possible so that it is centered over the work space below.

The holder was designed specifically to assist teachers and other educators as they transition to more online instruction in the face of the COVID19 pandemic.

If you are a teacher, this might be a good project to give to one of your students to build for you!

See here for assembly demonstration: https://youtu.be/8JX6UO-asPU

The sliding clamps are secured using 1/4" nuts with 3/4" long hex bolts. The best way to secure the nuts is by positioning them on the holes and heating them up with a soldering iron until they melt in to place. Alternatively, they can be press fit. The bolts fit tightly into the knobs. Use another bolt and hammer to get them all the way in if you need to.

Here are the parts you will need:

Everyone will need:

1/4" nuts and 3/4" long hex bolts 1 Base 1 Support Left 1 Support Right As many 5cm and/or 10cm Uprights to reach the height you need. Test your device first to see what height works best. My tablet works best at 30cm, which is approximately two 10cm uprights and one 5cm upright.

To use a phone:

1 Phone Holder Platform 2 Phone Holder Clamp Top and Bottom 1 Phone Holder Clamp Side

To use a Tablet:

1 Tablet Holder Platform 1 Tablet Holder Clamp Top 1 Tablet Holder Clamp Bottom 1 Tablet Holder Clamp Side Support Extensions Left and Right (these are needed to provide a larger base of support for tablets)

Knobs:

Each holder needs at least three knobs, more if you'd like it to be more secure.

This model is submitted to the November 2021 "DIY: Don't Buy 3D Modeling Challenge" in the "Household DIY" category. #custom #thangs3d #pdo