This model is restricted by licensing terms.
View license.
36 Likes139 DownloadsOctober 8, 2021
This model is restricted by licensing terms.
View license.
Despite what you might think, this is “Knot a Vase.”
The lattice structures are between 1.8mm – 2.0mm, so stick with a small nozzle. The model above was printed using a 0.4mm nozzle.
The pre-supported file has custom supports for the steepest sections, but with a structure like this it is inevitable that you will get small areas of print fail within the lattice. Best to clean this up with a small file afterwards than try to support every overhang.
36 Likes139 DownloadsOctober 8, 2021
This model is restricted by licensing terms.
View license.
36 Likes139 DownloadsOctober 8, 2021
This model is restricted by licensing terms.
View license.