This is a functional castle model designed to double as an accent lamp, gaming terrain, or a decorative nightlight. The windows and open gate are fully hollowed out to allow an internal light source to shine through.

I used two different types of LED strips to line the castle. Whatever LED strip you get, I'm sure it'll work great!

Each tower has cutouts at the bottom to accommodate your LED strip so there's no wire pinching. The "Roof" of each tower also has a slot cut out to allow you to route your LEDs up to shine on the roof.

Recommended sequence to route your LEDs:

1 - Back right tower 2 - Back left tower 3 - Front left tower 4 - Up around the front entrance 5 - Front right tower 6 - Along the wall into the back right tower again 7 - Diagonally out of the back right tower into the central tower (Position the center tower so the corner cutout is facing the back right tower

Printing Instructions:

• Layer height: 0.2mm
• Supports: None

Assembly:

• Refer to the attached assembly guide

Thank you for your time and consideration on this matter.

Feel free to join my discord for additional support, questions, or suggestions!