By confirming your subscription, you allow Thangs to charge your card for this payment and future payments in accordance with their terms. You can always cancel your subscription.
This model looks like a balloon but its actually a Wind Spinner. It prints all as one piece without supports. I used helper disc’s(brim), to make sure I had enough bed adhesion. I did not use z-hop but that might help keep the fins stable while printing if you have this issue. Your printer will also need to ability to make a 1” bridge. The model as downloaded is 232mm tall but I’ve printed it at 200mm and 300mm, I’m sure you could go taller or shorter than that.
Printed on the Muldex rep-rap IDEX printer with [Eryone Matte Dual Color PLA.
FYI… its PLA so keep out of the sun/heat.
Support and Licensing
If you would like to help support more free models, or get permission to sell physical copies of my models, consider joining my Patreon
