tracking pixel
Erin B

Rotating Radish Fidget + Garden

by
3DPmom
Follow
Follow
Remix Model
3DPmom
3DPmom
|
Image 1 of 9
Rotating Radish Fidget + Garden 3d model
3DPmom
3DPmom
|
Image 1 of 9
Rotating Radish Fidget + Garden 3d model
2D
3D
Makes
Rotating Radish Fidget + Garden 3d model
Rotating Radish Fidget + Garden 3d model
Rotating Radish Fidget + Garden 3d model
Rotating Radish Fidget + Garden 3d model
Rotating Radish Fidget + Garden 3d model
Rotating Radish Fidget + Garden 3d model
Rotating Radish Fidget + Garden 3d model
Rotating Radish Fidget + Garden 3d model
Rotating Radish Fidget + Garden 3d model
This model is restricted by licensing terms. 

These radish spinning tops might just become your favorite desk distraction;)

3D Print Settings: PLA works great Layer Height 0.2mm 15% Infill No supports needed

Dimensions of Radish: 1.5 in x 2 in.

Important Print the Radish Top and Peg with 15% infill Print the Radish Bottom with 60-70% infill (this is important because it lowers the center of gravity and helps it spin better:)

Note: I recommend printing these pieces on a smooth print plate so the bottom of each piece is real smooth and fit together nicely.

To print a multi-colored radish For Radish Top pause print at layer height 15.0 mm (or layer 75) to change the filament color (see photo) For Radish Bottom pause print at layer height 14.0 mm (or layer 70) to change the filament color (see photo)

I have also included a 3mf file with the following print profiles: Print Plate #1: Radish top & Radish peg, 2 colors: 15% infill Print Plate #2: Radish bottom 2 colors; 70% infill Print Plate #3: Radish garden bed of dirt, 1 color Print Plate #4: Radish garden planter box, 1 color

To assemble:insert the peg into the hole of the radish top and then the radish bottom connecting the two pieces together. You may also use superglue if necessary to secure the peg in place or the two halves of the radish together.

Have fun printing!


3 Likes14 DownloadsAugust 30, 2024


3 Likes14 DownloadsAugust 30, 2024
This model is restricted by licensing terms. 

Instructions

Filament • 0.2mm

MaterialPLA
Layer height0.2 mm
Infill density15 %
SupportsNone
BrimNo