tracking pixel
Erin B

Heart Layered Fidget (2 sizes)

by
3DPmom
Follow
Follow
Remix Model
3DPmom
3DPmom
|
Image 1 of 8
Heart Layered Fidget (2 sizes) 3d model
3DPmom
3DPmom
|
Image 1 of 8
Heart Layered Fidget (2 sizes) 3d model
2D
3D
Makes
Heart Layered Fidget (2 sizes) 3d model
Heart Layered Fidget (2 sizes) 3d model
Heart Layered Fidget (2 sizes) 3d model
Heart Layered Fidget (2 sizes) 3d model
Heart Layered Fidget (2 sizes) 3d model
Heart Layered Fidget (2 sizes) 3d model
Heart Layered Fidget (2 sizes) 3d model
Heart Layered Fidget (2 sizes) 3d model
This model is restricted by licensing terms. 

These small and large heart layered fidgets print in place and are very satisfying to play with💕

3D Print Settings: 0.2mm Layer Height PLA works great 15% Infill

Note: The layers of this print are thin (0.8mm), so to ensure a nice first layer, I recommend the following:

  • make sure your print plate is clean
  • use a smooth print plate
  • use a little glue stick on the print plate
  • slow the print down for the first couple layers (if I ever have any trouble with first layer adhesion on a print like this, slowing it down usually does the trick 😊)

Dimensions of Small Heart Layer Fidget: 2 ⅜ in. X 2 ⅜ in. X ⅞ in. Dimensions of Large Heart Layered Fidget: 4 in x 4 in x ⅞ in

You could scale up on these but I would caution about scaling down too much because that will make the walls thinner and decrease the spacing between the layers resulting in a less satisfying fidget 😞

Have fun printing!!


3 Likes7 DownloadsAugust 14, 2024


3 Likes7 DownloadsAugust 14, 2024
This model is restricted by licensing terms. 

Instructions

Filament • 0.2mm

MaterialPLA
Layer height0.2 mm
Infill density15 %
SupportsNone
BrimNo