Dragon Rider
After many, many adjustments and alterations in Affinity, I think I finally coaxed a compelling vision from Hueforge... shadowy beast and rider, boiling up from a maelstrom of cloud and fire... at least that's what I was aiming for :)
This print is 233 x 233mm in dimension, deeply textured and weighing in at 5mm deep with a 4mm blend depth.
Swap Instructions Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 233x233mm in size You may print at higher layer heights below the Min Depth of 0.96mm The Max Depth is 5mm and the Actual Depth is 5mm
Filaments Used: PLA Overture Black Transmission Distance: 0.6 PLA BambuLab Basic Cyan Transmission Distance: 1.9 PLA PolyTerra Charcoal Black Transmission Distance: 0.3 PLA BambuLab Basic Green Transmission Distance: 2 PLA+ Esun Dark Blue Transmission Distance: 2 PLA BambuLab Basic Magenta Transmission Distance: 3.4 PLA+ Esun Brown Transmission Distance: 1.5 PLA PolyTerra Army Red Transmission Distance: 0.3 PLA BambuLab Basic Orange Transmission Distance: 5 PLA BambuLab Basic Yellow Transmission Distance: 6 PLA BambuLab Basic Jade White Transmission Distance: 5 This print uses 11 unique filaments
Swap Instructions: Start with Black At layer #10 (0.88mm) swap to Cyan At layer #12 (1.04mm) swap to Black At layer #16 (1.36mm) swap to Charcoal Black At layer #19 (1.6mm) swap to Green At layer #21 (1.76mm) swap to Dark Blue At layer #22 (1.84mm) swap to Magenta At layer #23 (1.92mm) swap to Brown At layer #25 (2.08mm) swap to Army Red At layer #29 (2.4mm) swap to Orange At layer #38 (3.12mm) swap to Yellow At layer #46 (3.76mm) swap to Jade White for the rest