Growing some seedlings that need a little extra support? Here's your solution. Easy cages provide support to your young seedlings until they can grow big enough to support themselves.

These cages are comprised of using posts and fitting rings into the post holes. Posts have holes every approximately 25mm (1") so you can pick at which height your plants need support. Usually one post is enough but addtional posts can be used for extra support. Threading rings onto multiple posts can be a difficult fiddly task but can be done. All rings fit on all posts. Rings have been designed to have a nub on one end preventing the ring from falling out from being turned too far. This makes it only possible to fit rings through the post holes from one end. Just feel for the nub then fit into the post holes using the opposite end.

Post/Ring Sizes:

• 250mm Post (6 post holes)
• 200mm Post (5 post holes)
• 150mm Post (4 post holes)
• 100mm Post (2 post holes)
• 50mm Ring
• 40mm Ring
• 30mm Ring (probably the most used size)
• 20mm Ring

Printing instructions:

• Should print with standard settings.
• I used PLA but depending on the heat you expect your plants to be in maybe using a higher temp resistant material would be best.
• no supports needed.