Tired of that messy drawer filled with food storage bowls and lids? This is your solution. a modular organization system built to fit Anchor brand glass food storage bowls and lids.

The system is based on 212mm square blocks that are designed to fit specific different sizes of food containers and lids. There is two addtional 106mm half sized blocks designed for the smallest bowls and lids, and the large bowl lids only. See the dimensions included in the photo gallery for a better idea on sizes of all the models.

Use however many blocks of 212mm or 106mm best fit your drawer then you can fill any remaining space with a properly scaled to size spacer block. spacer block base size is 25mm x 25mm x 212mm long, you'll have to scale it wider in one of the 25mm orientations while keeping the 212mm dimension the same.

If the spacer block isnt for you I've included screw holes in each model for inserting small screws to secure your blocks. Additionally you could just use some double sided tape or rubber matting to keep the blocks from sliding around too much.

Printing instructions:

• some of these models are quite large (212x212mm) therefore use as little infill as possible to save on filament. I used 5-10% infill and the pieces turned out fine for me.
• depending on your printer quality at higher speed I'd definitely speed up these prints too I had to run some of them over night and then some.
• no supports are needed