Shelf Reeper you can pretty much print any size, just be aware if super small you may lose some detail in the face. Before you print just check the sliced model first. Printing... ok so i printed upright with support interface, however because most will not do that ive changed the orientation in the 3mf to print diagonally. The STL also has flat surfaces to print diagonally. While it still needs supports it's as minimal as it can be. I would suggest selecting manual supports and just paint critical regions. If you want to go auto supports even then there ant that many. Set the Top z to 0.275 for supports to just fall away otherwise it 0.2 layer, 10% infill.

Ive used bambu Glaxy Black, off white and red basic. also Bambu PLA sparkle grey