Melting Skull Tea light Holder with a couple of different options. Firstly ive included Two sizes. a large and small. both still fit on a 256x256x256. The inlet for the Tealight has of course been resized for each version. On top of that you can either have just the melting skull or you can add the drips so it becomes an on the edge of a self model. To add the drips does require some glue and is therefore permanent. there are small connecting block, mainly for lining up purposes. it does require some supports and my preferred settings are to set the top z to 0.275 for supports to come away easily. 0.2 layer, 10% infill