Low Poly Deer Planter There are two versions. A freestanding and wall mountable. the free standing can be scaled up or down to whatever, the wall mountable can be scaled a little only because of the crew hole mounts could become to large or small. it does print with out supports. Slice will give you a warning of overhangs and this is largely because of the chin which is on the cusp of not being able to print. I did use a support but you can support this are if you like. Printed in Bambu Matte Bine white. A favourite filament of mine, it just prints so nice. 0.2 layer, 8-10% infill. If you are planning on water or a chance of water being in the pot, id suggest 3 walls. which is what ive found to be fine for water retention.