Easy Print Fexahidget

174 downloads · 2 years ago · An easy print version of my fexahidget fidget toy. It is slighlty larger and has bigger tolerances

This model is restricted by licensing terms.

View license.

Description

An easy print version of my fexahidget fidget toy.

It is slighlty larger and has bigger tolerances

Prints without supports

Community Makes (3)

no way this is going to be not fused … will try a completely different filament in case this issue is filament specific

Community Makes (3)

Discussions

pezliz2 years ago

MRRF 2024 Handouts! Wish you were here!

ozjohnd2 years ago

Perfection! 🙏

ozjohnd2 years ago

no way this is going to be not fused … will try a completely different filament in case this issue is filament specific

ozjohnd2 years ago

sadly outcome is even worse .. my print looks nothing like the gaps in the images of the designer. I will use a completely different filament, tweak settings and try again. My suspicion is that this issue is filament specific.

ozjohnd2 years ago

ok it’s definitely the filament … I have just printed a model where I know the tolerances are tight but still permit movement and this filament fused in that model too.

Next task is to verify that a different filament will work well.

ozjohnd2 years ago

I have just started to print one with Bambu matte PLA and already I can tell this will work .. there is a visible gap between the bases of the columns after 4 layers. I will report back after the print finishes, I am printing by object 4 different Bambu matte PLA filaments.

ozjohnd2 years ago

Fully tested, failure definitely filament dependent.

I will post successful images separately.