Sometimes, a weird idea pops into my head, and I decide to model it. Yes, they are wearing Crocs.

This model originally started as a very NSFW design, but I felt I had gone a bit too far, so I turned it into this cute little guy instead. The legs drop and stay in place by pushing them out slightly.

Printing: If you look at my prints, you’ll notice that the overhangs on the green one look much better than on the middle finger dude. This isn’t due to supports but simply because of printing at a slower speed. So, my advice is to print it a bit slower than your usual models.

Supports are required for the eyes and eyebrows section, as well as for the middle finger arms. However, they are not needed for the top of the broccoli, as long as your printer handles overhangs well. Make sure to choose "supports on build plate only."

Scaling: You can scale up as much as you like. Scaling down was tested to 80%, but I assume it will work at smaller sizes to a certain extent.