nishihara179 followers

Gridfinity Tamiya Square Bottle Holder 1x2 3d model

Gridfinity Tamiya Square Bottle Holder 1x2

127 downloads · 4 years ago · Tamiya 40mm square bottle holder. One way and two-way slide out versions.

Description

Tamiya 40mm square bottle holder. One way and two-way slide out versions.

Community Makes (2)

REMIX of yesterday's REMIX!
Now the same model can be adjusted to hold a Tamiya's cement bottle, or Gunze's. The adjustable arms slide in a dovetail groove, allowing adjustment according to bottle size.

All that I said for the first Remix applies to this one. Let me know if you are OK.

Thanks! This is the most sensible Gridfinity model for the Tamiya cement bottles that I have found anywhere.
Having said that, this is a Remix. Because Tamiya's cement bottles are a notch too big, two (or more) prints of the original model do not fit side by side on my bases. So, I shaved a couple of mm from all sides. Now it fits (see pic of drawer). There is a caveat: since the bottle's size didn't change (duh), you can fit up to 6 bottles side by side. This is enough for my OCD. I intend to make a remix of your model for Mr. Cement as well. My main repository is Printables, so I will give you the credit there. OK? If this is not acceptable, I will delete the remix make there.

Community Makes (2)

Discussions

Kozure Okami7 months ago

Thanks! This is the most sensible Gridfinity model for the Tamiya cement bottles that I have found anywhere. Having said that, this is a Remix. Because Tamiya's cement bottles are a notch too big, two (or more) prints of the original model do not fit side by side on my bases. So, I shaved a couple of mm from all sides. Now it fits (see pic of drawer). There is a caveat: since the bottle's size didn't change (duh), you can fit up to 6 bottles side by side. This is enough for my OCD. I intend to make a remix of your model for Mr. Cement as well. My main repository is Printables, so I will give you the credit there. OK? If this is not acceptable, I will delete the remix make there.

PrinterBambu Lab A1

MaterialPLA

Layer height0.28 mm

Infill density15 %

SupportsTree

Kozure Okami7 months ago

REMIX of yesterday's REMIX! Now the same model can be adjusted to hold a Tamiya's cement bottle, or Gunze's. The adjustable arms slide in a dovetail groove, allowing adjustment according to bottle size. All that I said for the first Remix applies to this one. Let me know if you are OK.

PrinterBambu Lab P1S

MaterialPLA

Layer height0.2 mm

Infill density15 %

SupportsTree

nishihara3 years ago

I have used tree supports and also printed using custom supports in Cura. There may be a bit of clean-up but I tried to accommodate for that in the design in the fit.

CatchTheWind3 years ago

There are a lot of overhangs, how do you print the 1-way version?