Mother... Board. Get it?

This is a wonderfully detailed print where the contrast between the black and white coluors and the sharp lines of the circuit board and the woman's soft features creates a sense of mystery and intrigue.

This print is 200mm x 200mm. If you want to upsize or downsize this print, please do NOT scale the Z (height) dimension. Otherwise, go crazy!

Note: I used 2 different white filaments in this print, with different TDs. The higher TD is used first, and the lower one is used as the final layers. If you do not have different whites, you should be fine using a single white for the whole print, however you might lose a bit of the smooth transitions you see in the attached example print.

If you are using a Bambu printer, or Bambu Studio, the 3MF will already have all the necessary settings applied - you will just have to map your filament colours. If you are using the STL, please follow the instructions below:

Print Instructions: Print at 100% infill with a layer height of 0.04mm with a base layer of 0.20mm

Filaments Used: PLA Kingroon Black Transmission Distance: 0.4 PLA+ eSun Grey Transmission Distance: 1.4 PLA Kingroon White Transmission Distance: 8 PLA BambuLab Basic Jade White Transmission Distance: 5

Swap Instructions: Start with Black At 0.6mm swap to Grey At 0.92mm swap to White At 1.08mm swap to Jade White for the rest.

If you'd like to support me, I now have a Patreon!

Joining will give you behind the scenes information on WIPs, access to a private discord, early access AND exclusive models!

If you want to sell any physical models I have uploaded anywhere, an unrestricted commercial license is available on the $10AUD tier of my Patreon!