I got hooked 3D printing while building a scale model of an amusement park.  Note that since most of my models are designed with Blender, you’ll need to reduce their scale by 50% for printing.  

Activity related to collaborating with others on models

Likes, comments, and activity from your community

New content from your premium memberships

Emails and messages from designers you follow

Get notified when someone purchases your models or memberships

This is a recreation of the Eli Bridge Scrambler ride that was at Mountain Park in Holyoke, MA.  It was designed for my park model:  http://www.karenandjay.com/mtpark/mpmodel/mpmodel.html

Scrambler

These are the ride seats.  You'll need 12 of them.

scrambler-cab.stl

This is the ride center.  The button glues underneath the tall section.  The propeller-like section glues on top of the tall section so that all the horizontal struts line up.

scrambler-center.stl

If you'd like to enclose the ride, you can print out as many sections as you need.

scrambler-fence.stl

Print four of these.  Three of them get attached to the ends of the lower arms of the center section.  For the fourth one, snip off the arms and use those as vertical spacers between the center's top and bottom arms.

Scrambler

Scrambler

More models

Rings Pendant

1:144 Martinsyde G.102 "Elephant"

1:144 Martinsyde G.100 "Elephant"

1:144 Lohner B.VII

1:144 Lohner B.VII (Armed)

Pendant Ampères Law

1/350 Millennium Falcon Cockpit Interior and Window/Dish/Engine Replacement

IAR-80

Star Wars Death Star

Compact Tractor Mower Excavator Kit 2305 (1/87 Scale)

Compact Tractor Accessories Kit 2305 (1/87 Scale)

RAZOR CREST REVELL BATHROOM

1:144 Rumpler B.I

Pendant Emc2

1:144 Rumpler 6B1

Batman 2001

1:144 Paul Schmitt 7

RAZOR MANDO REBELL CARGO HOLD NETS W CRATES

Pickup Truck Camper Kit 1/87 Scale

1:144 Morane-Saulnier Type T