Plane Pegs (drilled)
3 downloads · 3 months ago · This is a set of forty-eight plane pegs compatible with Wings of Glory flight stands. These are _not
This is a set of forty-eight plane pegs compatible with Wings of Glory flight stands. These are not the flight/altitude pegs -- these pegs (or posts) are meant to be permanently attached to the bottom of a plane model. On the diagram in the gallery is marked red Sprue (waste), blue lead-in, and green pegs. To use these:
- Drill a roughly 1mm diameter hole (or slightly larger) in the bottom of the plane near its center of gravity, near the balance point of front-vs-back.
- Separate the lead-in and peg from the sprue and then trim the lead-in length to match the depth of the hole you drilled, or slightly shorter.
- Dry-fit the lead-in and peg.
- If the fit is good, you can take it apart and add some glue to the lead-in before re-inserting, to make the peg permanent.
There is also a flanged version of the peg that does not require drilling (though the joint may be of lower strength).
Plane Pegs (drilled)
1 print sold · 3 months ago in and
1:144 R.A.F. F.E.2d (Vee)
1:144 R.A.F. F.E.2d
1:144 Zeppelin-Staaken R.VI (R.52)
1:144 Zeppelin-Staaken R.VI (R.30)
1:144 Zeppelin-Staaken R.VI (R.25)
1:144 Siemens-Schuckert E.I
1:144 Sopwith Tabloid
1:144 Sopwith Schneider
1:144 S.I.A. 7b
1:144 Salmson 7
1:144 Sablatnig N.I
1:144 Rumpler G.III
1:144 Rumpler G.II
1:144 Rumpler G.I
1:144 Rumpler C.VII
1:144 Rumpler C.IV
1:144 Rumpler C.Ia
1:144 Rumpler C.I
1:144 Rumpler B.I
