Magnetic Headphone Stand

Arm.stl

Simple Paper Towel Holder

- Mounted 2 of these to a shelf I built previously. 
-Only 20% infill, its only holding paper towels...
- The hole spacing is 6 1/2" on center, specifically for the filament shelf I mounted using brackets inspired by 3D Printing Nerd. 
- These could also be wall mounted or to a similar shelf.

Alien Shelf Bracket v1

➤ My first upload. Just a simple shelf-bracket I created in Fusion 360.

➤ I used #8x2" (#8x5cm) wood screws. This is meant to be screwed directly into stud.

➤ I was able to print two of these brackets on my 235mm x 235m x 400mm buildplate.
(I had to expand the buildplate area from the default Ender 3 Pro setting in Cura. This is done by clicking "Preferences" in the top-left, "configure","printers","machine settings", and then changing the x and y printer parameters to "235" respectively. This increases the bed size to the actual limits of the Ender 3 Pro stock buildplate.)

➤ Print time is about 11 hours for two, or a little under 6 hours for one.

➤ I used these brackets to hang a shelf above our washer and dryer.

➤ I would love to see what others use this for! Thanks

Activity related to collaborating with others on models

Likes, comments, and activity from your community

New content from your premium memberships

Emails and messages from designers you follow

Get notified when someone purchases your models or memberships

zacattack257

Achievements

Seedling

Explorer

Debutant

Magnetic Headphone Stand

Simple Paper Towel Holder

Alien Shelf Bracket v1