Don't forget to leave a Like and Follow for more terrifying creations!
Vampire Bust with Wings and Fangs - Halloween Special STL Take your Halloween decorations to the next level with this spine-chilling vampire bust in STL format! 🦇 This haunting design features a classic vampire with its mouth wide open, revealing sharp fangs, ready to strike. Its wings are mid-flap, creating a dark and menacing atmosphere, perfect for adding an eerie touch to any space.
With creepy details and a gothic style, this bust is ideal for 3D printers and is sure to grab attention (and maybe souls!) wherever you place it. Print this vampire and bring your worst nightmares to life.
Perfect for horror lovers and those looking for a unique piece to complete their Halloween collection 🎃. Are you ready to invite this vampire into your home?
Parámetros de impresión 3D Filament (FDM) Print Settings for the Vampire Bust: Nozzle Size: 0.4 mm Layer Height: 0.1-0.2 mm (use 0.1 mm for higher detail) Print Speed: 40-60 mm/s (reduce speed for better detail on areas like the fangs and wings) Infill: 10-20% (increase to 30-40% for more durability) Supports: Yes, required for the wings and overhanging fangs (use supports at a 45° or lower angle) Extruder Temperature: PLA: 190-210°C PETG: 220-250°C ABS: 230-260°C Bed Temperature: PLA: 50-60°C PETG: 70-80°C ABS: 90-110°C Bed Adhesion: Recommended to use painter's tape, hairspray, or adhesive to ensure proper adhesion for the wings and finer details. Cooling Fan: On for PLA and PETG; off or low for ABS. Resin (SLA/DLP) Print Settings for the Vampire Bust: Layer Height: 0.05 mm (50 microns) for fine details. You can reduce to 0.025 mm (25 microns) for maximum detail on the wings and fangs. Exposure Time per Layer: Base layers: 8-10 seconds. Normal layers: 2-3 seconds. Supports: Essential for the delicate details like the wings and open mouth. Use medium to fine supports in these areas. Print Angle: Tilt the model by 30°-45° to optimize support distribution and avoid print failures. Post-Print Curing Time: 3-5 minutes in a UV curing machine, depending on the power of the machine and resin type. Cleaning: Clean the print with isopropyl alcohol (IPA) to remove uncured resin before the final curing process. These settings will help you achieve high-quality prints, whether you use filament or resin for this terrifying vampire bust.