Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4585921.

A case for the NOIR camera and Bright Pi board, for use with Austin George's [Ender 3 Raspberry Pi Camera Mount](https://www.thingiverse.com/thing:3188580)

This was designed based on the header being soldered on the opposite side from the LED's

There is an arrow marking where the ground pin should be but since it is possible to solder things the other way around, pay attention to where the ground pin is before putting the boards in the case.

The mounting arm seems long until you attach the cable for the Bright Pi, then you need the length to be able to tilt the camera back.

There is a bit of an edge on the back and a corresponding recess in the body, so the back *should* snap in place. 

Bright Pi Camera Case

Drive mounts for HP G2 800 Mini 2.5" Drive.

I use a G2 mini for some experiments and testing so am swapping the drive fairly regularly.  Rather than swapping the mount points between drives I created these. 

Notes:
There may be an issue using PLA if the G2 Mini runs very hot, I'd probably recommend PETG or ABS for long term use, but for my purposes they are fine.

Hardware Required
- 4 x M3x8mm Cap Screw.
6mm should work in most cases, but 8mm is closer to the original mount.



HP G2 Mini Drive Mounts

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4695076.

Sleeve to protect a 3D or BL Touch Sensor, and cover the LED

After my Touch sensor crashed into a part that came off the build plate, I wanted a shield for it.  I also wanted to cover the LED as it was overly bright in my captures.  

I designed it from scratch in OpenSCAD to go over the sensor from the bottom, so the probe is protected unless deployed, and it replaces any nuts used for mounting the sensor, just 3mm bolts into the sleeve (I tapped the holes, but you should be able to put bolts in without tapping (do so before trying to mount in place).

It's fairly tight to the sensor but may require adjusting of the mount used so the sleeve clears other parts.



Sleeve for 3D/BL Touch Sensor

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

xrxca

Achievements

Seedling

Bright Pi Camera Case

HP G2 Mini Drive Mounts

Sleeve for 3D/BL Touch Sensor