This 6in drum would make a perfect addition to any drummer's arsenal.

Printed in PLA

It uses 65mm M5 screws with a M5 T-Nut. (I have linked the ones I used.)

I included two different shell heights. 70mm and 60mm.

I used a soldering iron to insert the T-nuts into the bottom “lug”.

Once the t-nuts are in place just find a 6in drum head. I have used 3 types on this drum and they all work wonderfully.

I have also included an snare attachment.

Hardware

Screws: 65mm M5 screws

Nuts: M5 T-Nut

Drum Heads

Printed: https://www.printables.com/model/1216377-tpu-drum-head-or-frisbee

Traditional: https://www.sweetwater.com/c1027--6_inch_Drum_Heads?all&sb=low2high

Mesh: https://www.sweetwater.com/store/detail/SN0006--remo-silentstroke-drumhead-6-inch

Print Settings

For the rims and drums walls are the most important infill percentage and type can vary.

Rims Walls - 8 Layer height 0.2mm Top Shell Layers - 6 Bottom Shell Layers -7 Infill - 10% Cubic Drums Walls - 8 Layer height 0.2mm (I also printed at 0.24 with no problem) Top Shell Layers - 6 Bottom Shell Layers -7 Infill - 7.5% Adaptive Cubic

Accessory

Snare attachment Walls - 2 Layer height 0.16 mm Infill - 10% Gyroid