tracking pixel
Michael W

Dragon Skull Incense Burner

by
wessels.creations
Follow
Follow
Remix Model
wessels.creations
wessels.creations
|
Image 1 of 5
Dragon Skull Incense Burner 3d model
wessels.creations
wessels.creations
|
Image 1 of 5
Dragon Skull Incense Burner 3d model
2D
3D
Makes
Dragon Skull Incense Burner 3d model
Dragon Skull Incense Burner 3d model
Dragon Skull Incense Burner 3d model
Dragon Skull Incense Burner 3d model
Dragon Skull Incense Burner 3d model

A dragon skull that drips smoke from the nose from backflow incense cones. Looks great as it develops colour from the incense over time, accentuating the sculpted form. The skull is roughly 25cm (9.8") long, fits vertically on a bambu X1Carbon. Displayed model was printed in PLA with tree supports. Support blocker used in the tunnel in the nose to keep it open/clear.

******Designed to use a ceramic insulator that the incense sits in, so that the plastic does not melt/deform over time. They can be found on Amazon here: https://shorturl.at/iFlcR

Suggested you use a clear coat spray paint to seal the model so that the incense oils don't wick into the layers over time. A couple layers on the outside as well as a couple short sprays into the top hole, then holding it with the nose pointing down for a minute or two to seal in inside of the tunnel.

**Burning incense poses a risk of fire, as well as producing particulate that may cause harm. Heated plastics may off-gas and can cause harm from continual exposure. Never leave burning incense unattended, as plastic is also flammable and can lead to property damage or injury.


1 Likes0 DownloadsAugust 13, 2024


1 Likes0 DownloadsAugust 13, 2024

Instructions

Filament • 0.2mm

Layer height0.2 mm
Infill density10 %
SupportsTree