I cannot use the original drip tray as it does not allow me to fit my favorite cup. I do tend to forget to put my cup in place at least once a week however, which then results in a big mess… sigh…

For that sole reason i decided to print my own drip tray which is just a tad less tall than the original. If I now forget to put my cup in place, the coffee is at least not all over the place.

I've printed this on my Prusa Mini+ with 100% infill. I've added a cut-out for a small magnet as in the original.

The design is publicly available on Tinkercad, so you can easily adjust it to your liking. I added the cut-out for a magnet as a last step, so you can ungroup and remove it or replace it with a different sized one.

https://www.tinkercad.com/things/7eqDsXdjp3v