WALL CD v0.stl

GOOD 3D OBJECT TO ORGANIZE YOUR WALL CHARGERS

.2 LAYER HEIGHT
WALL LINE COUNT 2
INFILL 15%
SPEED 60M/S

LETTERS!!!!!
.2 LAYER HEIGHT
WALL LINE COUNT 3
INFILL 35%
SPEED 60M/S

WCDT v0.stl

V3D HAMMER v2.stl

hammer

.2 layer height
60 mm/ sec
4 wall line count
60% infill
supports (yes)


Spiral_Vase.stl

My Cura Vase settings

: LAYER HEIGHT .2
: INITIAL LAYER LINE WIDTH 110%
: WALL THICKNESS 3
: WALL LINE COUNT 7
:BOTTOM THICKNESS 3
: BOTTOM LAYERS 15
:INITIAL BOTTOM LAYERS SAME AS ABOVE
:OPTIMIZE WALL PRINTING ORDER CHECK
: OUTER BEFORE INNER WALLS CHECK
:COMPENSATE WALL OVERLAPS CHECK
:FILTER OUT TINY GAPS AND PRINT THIN WALL CHECK
:INFILL DENSITY 0%
:PRINT TEMP 205
:PRINT TEMP INITIAL LAYER 210
:INITIAL PRINT TEMP 205
: FINAL PRINT TEMP 200
: BUILD PLATE TEMP 60
:PRINT SPEED 50
:ENABLE RETRACTION CHECK
:RETRACT AT LAYER CHANGE CHECK

IM USUING A BMG EXTRUDER MY RETRACTION MAY BE DIFFERNT YOU WILL HAVE TO FIGURE YOUR RETRACTION SPEEDS

PRETTY MUCH THATS IT OTHER THAN YOUR NORMAL SETTINGS 

HOPE THIS HELPS



Yard Markers

in slicer program orientate part flat this will allow you to change different colors as needed for this part, you will need supports under the flag section. NOTE!!!!!! people have made metal extensions to put these in the ground for extended height (metal tube) you can buy at lowes ect

8.5 FLAG 10 YD 1.stl

punch v1.stl

punch to help break off supports if needed

cura settings
layer height .2
shell (wall line count)=8
infill density 40%
i used red pla plus
machine cr6se

victory3d

Achievements

Seedling

Debutant