tracking pixel
Diogo I

MICROSCOPE FOR PEDAGOGICAL USE, FOR TEACHING OR SHOWING.

by
uniduni3d
Follow
Follow
Remix Model
uniduni3d
uniduni3d
|
Image 1 of 2
MICROSCOPE FOR PEDAGOGICAL USE, FOR TEACHING OR SHOWING. 3d model
uniduni3d
uniduni3d
|
Image 1 of 2
MICROSCOPE FOR PEDAGOGICAL USE, FOR TEACHING OR SHOWING. 3d model
2D
3D
Makes
MICROSCOPE FOR PEDAGOGICAL USE, FOR TEACHING OR SHOWING. 3d model
MICROSCOPE FOR PEDAGOGICAL USE, FOR TEACHING OR SHOWING. 3d model

Simplistic design of a Microscope for teaching or introduction to science. Made for 3d printing, without any use of scaling, only for ludic learning.

3d printing: ALL PARTS: 3 Perimeters, 4 Top layers, 4 bottom layers minimum. BOLA1 AND BOLA2 - Printing with flat surface on bed. BASE MICROSCOPIO - Print with side surface on bed, for no overhangs. (Usually dont need support). CONECTOR BOLA - (connecting piece of BOLA1 and BOLA2) - flat surface on bed. ESPICULA - (Spikes) - Print with bigger flat surface on bed, use a different color from BOLA1 and BOLA2 for better aesthetics.

#Use CA glue for Glueing after printing.


3 Likes6 DownloadsSeptember 23, 2022


3 Likes6 DownloadsSeptember 23, 2022