DigitalDigital Store
Bundle
PrintsPrint Store
My Thangs
Access 15,000+ models$14.99/month
DigitalDigital Store
Bundle
PrintsPrint Store
My Thangs
Access 15,000+ models$14.99/month
profile hero image
theozroth’s profile picture

theozroth

0 followers0 downloads

Achievements

25 Models downloaded badge
Trailblazer
25 Models downloaded
First Make published badge
Novice Maker
First Make published
All
Sort by:

PEN HOLDER GHOST / PEN ORGANIZER HALLOWEEN EDITION

PEN HOLDER GHOST / PEN ORGANIZER HALLOWEEN EDITION - Both prints: Prusa Smooth PEI sheet. Ironing enabled. Generic super glue to connect the eyes to the body. Room temperature 72F, no enclosure. Filament kept Prusa MK4 filament holder, no filament dryer (traveling for holidays). Eyes: printed at 10% infill; 2 minute completion time. Inland PLA+ (Black) with "Generic PLA" settings in Prusa Slicer. Ghost: 1h 35min completion time (details above). Monoprice PLA (White), approximately 17 years old but only recently opened. Temp: 215F nozzle for all layers, bed 60F for duration of print. I used the default supports in Prusa Slicer, but noted they did not go across the full arm. I regret not painting on additional supports (I considered doing so briefly) as a hole developed in the right armpit. I used a few tools to clean up the stray filament that hadn't bridged correctly for the arm, as well as the undersides of the arms where the supports had connected. Functions as intended. - 3d model