This model is restricted by licensing terms.
View license.
7 Likes80 DownloadsOctober 4, 2023
This model is restricted by licensing terms.
View license.
This is another attempt for a Filament-Cutter Base module without servo. A bit more refined than my previous model. For this gadget to work, you'll also need the Push-Pin mounted somewhere on the 3D-Printer frame at the right position. Unfortunately, there's no "one-size-fits-all" solution to this. The shown Push-Pin will fit on a Creality CR-10 Smart gantry without modification though.
Here's a short on YouTube where you can see it in action.
Category:
7 Likes80 DownloadsOctober 4, 2023
This model is restricted by licensing terms.
View license.
7 Likes80 DownloadsOctober 4, 2023
This model is restricted by licensing terms.
View license.