tracking pixel
Technik G

Ender-3 Riser Feet 100 mm

by
technik.gegg
Follow
Follow
Remix Model
technik.gegg
technik.gegg
|
Image 1 of 4
Ender-3 Riser Feet 100 mm 3d model
technik.gegg
technik.gegg
|
Image 1 of 4
Ender-3 Riser Feet 100 mm 3d model
2D
3D
Makes
Ender-3 Riser Feet 100 mm 3d model
Ender-3 Riser Feet 100 mm 3d model
Ender-3 Riser Feet 100 mm 3d model
Ender-3 Riser Feet 100 mm 3d model
This model is restricted by licensing terms. 

This is a very simple print used to raise the Ender-3 (or similar clones using 2040 extrusions) to 100 mm. Very useful if you have a ton of stuff to cram below the printer.

Print these parts 4 times, 2 of them mirrored. It's best using ABS / ASA / PETG for the Outer and Inner parts. The Bottom part needs to be printed from TPU, if you don't have the ones that came with the printer, but can also be cut out from a rubber mat and glued it into the groove at the bottom.

After printing, snap the Inner part into the Outer part, if you want, you can add a bit of superglue.

Please notice: When attaching those feet to your printer, it's supposed to be a very tight fit, so they won't slip.


8 Likes27 DownloadsAugust 4, 2022


8 Likes27 DownloadsAugust 4, 2022
This model is restricted by licensing terms.