Electronics Case (SKR+Relay+Buck) for E3 V3.0 controller

This housing is a modification of my previously published model, the SMuFF Electronics-Case (SKR+Relay+Buck) New.

I had to modify this housing since the SKR E3 V3.0 is 4mm longer (2mm on each side) than its predecessors, the E3 V1.2 / V2.0/ -DIP V1.1.

**Please notice: Do not print this, if you intend using one of the older boards. **

It keeps the controller, the Velleman VMA 400, Elegoo 4 or SMuFF mini relay board, the LM2596 or SY8205 buck converter and a display (DIY OLED, LeoNerd's OLED Module, BTT TFT 2.4, or FYSETC 12864 Minipanel) all in one place.

The display lid has to be printed flat and then bent to meat the upper angle. Right after it has been printed, let the bed cool down, then remove it from the bed, put it down on the bed again and heat up the bed to 5-10 deg. above the glass temperature of the material (60-70 deg. C for PLA, for example). Wait 10 minutes then bend the lower part until the gap closes.

This STEP files comes also with two lid templates for your own display integration.