This a complete chassis for Drommon's King Axles. It is centered around the use of a Wheely King transmission and shock towers (what I had on hand, fairly easy to find). Printed in PLA at 100% infill and 0.2 layers. Uses RC4wd M3/M4 rod ends and 20mm M4 set screws for the links.The cage is optional and gets in the way of battery installation but looks good. It is designed to use shorty lipos (again, what I have on hand). The center driveshafts are from a 3.3 T-Maxx. The one piece chassis plates require a 300x300 bed to print (CR-10).