tracking pixel
Super F

Qidi Plus 4 Excess Chute

by
superflu
Follow
Follow
Remix Model
superflu
superflu
|
Image 1 of 3
Qidi Plus 4 Excess Chute 3d model
superflu
superflu
|
Image 1 of 3
Qidi Plus 4 Excess Chute 3d model
2D
3D
Makes
Qidi Plus 4 Excess Chute 3d model
Qidi Plus 4 Excess Chute 3d model
Qidi Plus 4 Excess Chute 3d model

This is a standalone Qidi Plus 4 Excess Chute (poop chute). Very simple but works wonders. The base is hollow so you can optionally glue a magnet to keep the chute in place.

Print tips:

  • Optional - Since the chute is located next to the exhaust fans, I prefer ABS based materials to PLA or PETG, but I doubt the temperature reaches something that would affect PLA/PETG. I opted for ABS-GF, which is my go to filament for just about anything because of its strength and low warping.

  • Optional - I recommend a brim of 5mm since the model is large.

  • No supports needed - I chamfered any angle that would otherwise require supports.

  • Print at any resolution really, I recommend 0.2+. There is no reason to print this with resolution below 0.2.


1 Likes4 DownloadsNovember 8, 2024


1 Likes4 DownloadsNovember 8, 2024

Instructions

Filament • 0.2mm

MaterialPLA
Layer height0.2 mm
Infill density15 %
SupportsNone
BrimYes