Hextraction Board for Small Build Plates (at least 148mmx153mm)

Print a Hextraction board on your Prusa Mini+ or other small printer! Print two of the A sections and two of the B sections to replace the standard 5-15 and 5-7 plates. Five of the original clips are needed, as well as two of the slightly modified clip included here.

I wanted to print Hextraction, but I found that the included board sections were much too large for my Prusa Mini+'s print bed. Since Zack made the original Fusion 360 files available, I was able to create 7 segment and 4 segment sections that fit together to create the original board. To ensure strength between the parts, I also created tweaked clips with “tabs” on both sides to fasten pieces on a side (as opposed to the original clips, which are designed for only top/bottom fastening).

Check out the images to see how things fit together and what I believe are the optimal clip locations. The custom clips are placed horizontally between the 7 segment and 4 segment pieces, and the original clips are placed on the 5 horizontal borders between the top and bottom sections.

Make sure your board notches are aligned before you glue!

Finally, check out Hextraction at https://www.playhextraction.com!