Nerf Gecko Heatset Insert Jig - Frame.stl

this is just a simple screw jig to help when installing the heat inserts into the rear frame of the Nerf Gecko blaster by Ehdrien. (https://www.etsy.com/ca/listing/957928696/the-gecko-3d-printed-foam-dart-blasting)

getting those inserts at just the right angle is a bit tricky, as they have to match the guide holes on the front half of the frame. It's just easier to use the jig than to have to handle the other entire front frame for the same job.

to make the jig I just sliced and diced the STL's for the front half and kept the exact geometry for the holes, filled in the missing gaps and added a short handle.

works great and is easy to print. _____ NON-COMMERCIAL USE ONLY ____

enjoy.