Scott S

Amiga 500/600/1200 PSU Enclosure - Meanwell RT-50B

by
ssouthur
Follow
Follow
Remix Model
ssouthur
ssouthur
|
Image 1 of 3
Amiga 500/600/1200 PSU Enclosure - Meanwell RT-50B 3d model
ssouthur
ssouthur
|
Image 1 of 3
Amiga 500/600/1200 PSU Enclosure - Meanwell RT-50B 3d model
2D
3D
Makes
Amiga 500/600/1200 PSU Enclosure - Meanwell RT-50B 3d model
Amiga 500/600/1200 PSU Enclosure - Meanwell RT-50B 3d model
Amiga 500/600/1200 PSU Enclosure - Meanwell RT-50B 3d model

This is an enclosure based around my (vague) memory of the Amiga PSU's (I also have one for Amiga 500/600/1200's). This enclosure is designed to house a Meanwell RT-50B power supply (+5V/+12V/-12V_, and includes cut outs for an IEC connector (aka Kettle cord) and a switch.

Print the lid with the top down, the base with the bottom down, the cable clamp with the "grip" up and the logo plate however you'd like. Use supports with an XY separation of 1.2+mm (so it doesn't put supports in the vent - the vent will print without supports just fine).

And please post makes!!!

The extra parts needed are (as near as I can tell - I bought my parts from Jaycar in Australia - though they didn't have the 4 pin DIN):

4 x Large screws (Join lid to base) 2 x Small screws (For cable clamp) 1 x IEC Socket 1 x 240V - 10A Switch 1 x CD32 4 pin DIN 2 x Mainboard Screws 1 x Meanwell RT-50B 4 x Rubber feet - 12mm


0 Likes1 DownloadsNovember 8, 2024



0 Likes1 DownloadsNovember 8, 2024

Instructions

Filament • 0.2mm

MaterialPLA+
Layer height0.2 mm
Infill density10 %
SupportsGrid
BrimNo