Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5796898.
Cupholder adapter to add a 3rd cupholder slot to the 3-series e46. Designed and fitted for a e46 330xi, this cupholder replaces the existing coin tray and rotating assembly.
The top tier (95.4mm) fits the 32oz and 40oz Hydroflask (91mm diameter) and some silicone boots.
1.1 Revision
Tier 1 Minor Diameter trim (84mm - 78mm) Alignment Guides for plastic tensioners Skirt fitment and trim
1.2 Clip Fitment and Reinforcement Fastening Peg Alignment
Print however you want, vertically hides imperfections, and support is always a nightmare to remove. Be careful of the standoffs and alignment posts when removing supports- they have been reinforced as well as the fixing clips on either side (as these are the common points of failure). Tree support helps ALOT, but take your time.
PLA IS NOT sufficient for Florida summer days and deforms in direct hot sunlight. Print out of ABS for this reason if applicable