Replacement Leg for Tripp-Lite monitor stand MR1411M

Replacement leg for Tripp-Lite monitor stands models MR1411M and MR1812M. Would probably also work with the triangular MR1220M if you remove the "wings" that go on the outside of the metal lip.

Print on its back. Supports are required for the section with the screw hole. Fits an M6 nut that is roughly 6 mm thick.

I've generated STLs for the lengths stated in the manual, but the F3D file will allow for legs of any length. You will not be able to get too short and legs that are too long may be too weak.

As 3 of my legs were fine, I did not include any provision for adding a rubber foot.

The default STL is 140 mm.