Hello hope you like this faucet leveling tool, all you need is a bubble level of diameter 7.8mm. Print and slide the bubble level in the slot and you are ready to go.

Dont forget to send your comments on how i can improve the design.

Enjoy...Cheers

Faucet Leveling Tool

Tool.3mf

Hello, rotate the top part so that you won't need support. Hope you like this thing, don't forget to leave a comment on how to improve the work and upload your makes.

Enjoy...Cheers

Bullet Toothpaste Squeezer

Top.3mf

Hello this is a stand for your Oral B 9 series. Just print and insert the charger at the bottom and slide your toothbrush. This will avoid your tooth brush from falling from the stand when in the bathroom.

Dont forget to send some comments and your makes. 

Enjoy....Cheers

Oral B 9 series Stand

Body.stl

Hello, I design this gutter filter cap / anti rodent, to keep wild animals from entering my drain pipe.

The diameter is 50mm and there is an offset space where you can add some silicone paste for better adhesion. This cap is installed on wall where drain pipe end open.

Hope you like this one and don't forget to send me a comment for improvement.

Enjoy...Cheers

Gutter Drain Filter

Gutter.stl

Hello, this japanese lamp is very practical for kids room or even in a living room. 

Print all the files, the side panels should be printed side down with the 45 degree angle facing up.

Add your light bulb and support of your choice on the base with the wire going through the premade hole. I didn't make hole for the button as I used sensor switch instead. 

Glue lampshade paper or paper of your choice to the panels and slide all the panels together, glue the four panel to the base and lastly glue the top panel...et voila!!

Hope you like my lamp and don't forget to comments for any improvements.

Enjoy...Cheers

Japanese Table Lamp

1.stl

Hello this is a measuring tape casing for stylist and hobbyist. Hope you like the design and comment on how I can improve it.

Dont forget to share your makes.

Enjoy...Cheers

Soft Measuring Tape Casing with keychain holder

Pivot.stl

Hello, this turntable is very simple and all you need is an old motor from a broken microwave and a switch. The design is fully parametrised. I have added a rail that can be filled with ,“metal ball” dont know the exact name,  for smooth turning.

Send me your prints and some advise on how we can improve this model.

Enjoy…Cheers

Fully parametrised ultra lowcost turntable for 3D Scanning

Base.stl

Hello a little something for your love ones. All the letters and vase is detachable.

Enjoy...Cheers

Valentines Day Stand

vase.stl

Hello here are two funny toilet signs that I designed in Fusion 360. I'm still a novice but hope you like it guys. 
 

Enjoy…Cheers

Funny Toilet / Bathroom Signs

toilet_man.stl

Hello this is my first design in fusion 360,  3D Vernier Caliper Case. I could not print it for my vernier caliper as my print bed is too small. So if anyone is printing it, please share the result with me.

Any advice on how to improve this thing is most welcome.

Cheers

Parametrised Vernier Caliper Case

Vernier Parametrised.stl

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

serialkillaz240384

Achievements

Seedling